(Yes, if you have a pretty acrylic top, you are going to be sticking a camera to the inside of it.) Focus your laser on it, like you would if you were going to engrave it.į ind the center of your bed, and measure straight up to the lid in inches and write this number down. G o to your laser, and place a small block of wood or something reasonably flat on the bed. Look in the column Minimum Mounting Height. LightBurn will then display all the available cameras. The easiest way to determine which camera you need is to install LightBurn, get it set up for your laser, and perform the following st eps:Ĭ lick on Help->Camera Selection Help from the top menu. With every model of LightB urn C ameras you will need to select the degrees for the lens. LightBurn Camera Selection and Installation: They have the same physical size as the 5MP, with a higher resolution sensor and a 4:3 aspect ratio.Ĩmp, High-Resolution, Wide-Angle - These cameras are typically best for lasers with beds over 1000mm. There are three variations of cameras offered:ĥmp, Standard-Resolution, 4:3 Aspect Ratio - These are the standard LightBurn cameras.Ĩmp, High-Resolution, 4:3 Aspect Ratio - These cameras fall between the 5mp standard cameras and the 8MP wide-angle cameras. Watch this v ideo showing benefits of the LightBurn Camera. A LightBurn Camera, which works in conjunction with LightBurn software, will allow you to position projects on your material, trace artwork from the bed of your laser, and provide some monitoring for your laser.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |